Pages Navigation Menu

Tiny House Update: Reclaimed Floors

Hello fine folks – it is February 10th and we are right in the middle of our reclaimed fir flooring install. As you recall, this old shiplap flooring is being installed directly over the Warmboard subfloor and pex water tubing…

IMG_0010

Tools we are using for the flooring install:

Table saw, chop saw, drill for installing 2  inch screws, finishing nail gun installing 2 and 1/4 inch nails, sander – NO GLUE or other adhesives are being used… The flooring has rich color and patina from the years of prior use in a grain bin in Washington state. We obtained the reclaimed flooring from our sponsors, Heritage Salvage in Petaluma, CA, about 50 miles from us. One side has the old patina and wear and other side has been freshly milled by Heritage. The boards are 5/8 inch in height and 5 inches in depth and vary from 3-10 feet in width.

WE ARE DOING THE WORK OURSELVES…. Yahoo!!! Another update will come once we finish the floor install and go onto the sanding/buffing/staining ritual.

10411130_816504031720725_8607839845335708936_n 10931116_819213518116443_1690628987360103452_n 10943074_816504098387385_3113452179982981984_n 10955218_816504035054058_3806934305991481338_n

10406648_816504085054053_2050574125615755085_n 10940619_816521148385680_3347023021658999827_n

 

2 Comments

  1. hi there, looks awesome! have you ever done radiant heat with warm board in an Airstream renovation ? we have the body off now and are soon to put in a new subfloor. i want radiant heat and am wondering if it is too risky to use warm board and water heated. we are making a tiny house, not an rv. thanks so much!

    • Hi Barbara – no we haven’t attempted that in an RV. I would be cautious of the extra weight, ya know?

Leave a Comment

Your email address will not be published. Required fields are marked *

Pin It on Pinterest